![]() Bimmerworld Carbon Fiber Center Dash Plate Sparco Quick Release Hub (Black anodized) VAC Motorsports underdrive power pulleys Bimmerworld Oil Cooler Diverter Valve Kit Bimmerworld CSL 120mm carbon intake plenum ![]() Car dyno’d from previous owner sea level (320whp/244tq) Competitive GTS3 drivers and shop in Denver area have driven and can attest to the work done and its condition to go racing. Car has ~79K on it, straight body, no frame damage, and the underbody shows that is has not been exposed to any salt areas. Please e-mail or call with any questions - I do not have a dyno sheet for the car at altitude but can easily run the car over to be done if needed by the buyer. Literally the car needs nothing and I would take it out and race it tomorrow. No issues in passing NASA/SCCA tech and as you can see from the rear shots - tied in beautifully to the right points providing extra rigidity. This car 's cage was overbuilt, and the craftsmanship is impeccable. I am sure I am missing a lot in terms of the below parts outlined, the most important are the specifications on the cage. 2022 plans were to run this in GTS3, car has NASA as well as SCCA logbooks and was just in for all major fluid changes/any maintenance required. Essentially a Bimmerworld parts catalog car, this is lightweight, competitive and built off a low mileage E46 platform. ![]() I spent a long time looking for the right GTS car, and this is it. This car is all set and ready to race - fresh fluids and new tires.
0 Comments
Leave a Reply. |